Helmet Choice Comes Down To The Mix Of Processes You Run And How Much You're Prepared To Spend For Extra Sensors Or A Wider Shade Range, And It's A Straightforward Conversation To Have With A Stockist That Carries Several Options, Including TEC Products.

Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.

Helmet choice comes down to the mix of processes you run and how much you're prepared to spend for extra sensors or a wider shade range, and it's a straightforward conversation to have with a stockist that carries several options, including TEC Products.

The figure changes with output. Turn the amperage down and the duty cycle climbs, because the internal components are working less hard. This is why a welder can feel completely different in a busy production environment compared with occasional home workshop use: someone welding continuously through a shift needs a much higher duty cycle at their working amperage than someone doing short repair jobs a few times a week. It's the kind of spec worth comparing properly across brands such as Kemppi and EWM, not just reading off the headline amperage figure.

The abrasive material itself matters as much as the shape. Discs formulated for steel typically contain aluminium oxide, while stainless steel usually calls for an inox-rated disc that's free from iron, sulphur and chlorine contaminants that could otherwise cause surface corrosion on the stainless. Aluminium and other soft, non-ferrous metals need their own dedicated abrasives too, since standard steel discs tend to clog quickly and produce a poor finish on softer materials.

Portability and power supply matter as much as the process itself. A stick welder will run from a generator or a domestic supply in places a gas bottle can't easily follow, while MIG and TIG set-ups need a gas cylinder and, for anything beyond light-gauge work, a heavier electrical supply. Workshop layout, the materials you weld most often, and how frequently the machine needs to travel are all worth weighing up before settling on one process.

Welding produces fume made up of fine particulates and gases, and the composition varies depending on the process, the filler material and any coatings on the base metal. Fume rises from the arc and, without adequate control, can build up in the breathing zone of anyone working nearby, which is why extraction is treated as a core part of workshop set-up rather than an optional extra.